Toro 74919TE - Adjusting the Anti-Scalp Rollers

AdjustingtheHeight-of-CutPin
Adjusttheheight-of-cutfrom25to140mm(1to
5-1/2inches)in6mm(1/4inch)incrementsbymovingthe
clevispinintodifferentholelocations.
1.MovethetransportlocktotheLOCKposition.
2.Pushonthedeck-liftpedalwithyourfootandraise
themowerdecktotheTransportposition(alsothe
140mmor5-1/2inchcutting-heightposition)as
showninFigure26.
3.Toadjust,rotatethepin90degreesandremovethepin
fromtheheight-of-cutbracket(Figure26).
4.Selectaholeintheheight-of-cutbracketcorresponding
totheheight-of-cutdesired,andinsertthepin(Figure
26).
5.Pushonthedecklift,pullbackonthetransportlock,
andslowlylowerthemowerdeck.
Figure26
1.Deck-liftpedal
3.Transportlock
2.Height-of-cutpin
AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheightofcut,adjusttheheight
oftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),movethe
motion-controlleverstotheNEUTRAL-LOCKposition
andsettheparkingbrake.
2.Shutofftheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Adjusttherollerstomatchtheheightofcut.
Figure27
1.Anti-scalproller4.Flangenut
2.Spacer
5.Bolt
3.Bushing
Figure28
1.Anti-scalproller3.Flangenut
2.Bushing4.Bolt
Figure29
1.Flangenut4.Anti-scalproller
2.Spacer
5.Bolt
3.Bushing
25