EasyManua.ls Logo

Toro 74919TE - Adjusting the Motion-Control Linkage

Toro 74919TE
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure86
5.Iftheendsofthelevershitagainsteachother,refer
toAdjustingtheMotion-ControlNeutral-LockPivot
(page56).
AdjustingtheMotion-Control
Linkage
Thepump-controllinkagesarelocatedoneithersideofthe
fueltank,belowtheseat.Rotatethepumplinkagewitha1/2
inchwrenchforne-tuningadjustmentssothatthemachine
doesnotmoveinneutral.Makeanyadjustmentsforneutral
positioningonly.
WARNING
Theenginemustberunningandthedrivewheels
mustbeturning,sothemotion-controladjustment
canbeperformed.Contactwithmovingpartsor
hotsurfacesmaycausepersonalinjury.
Keepyourngers,hands,andclothingclearof
rotatingcomponentsandhotsurfaces.
1.Priortostartingtheengine,pushthedeck-liftpedal,
removetheheight-of-cutpin,andlowerthedeckto
theground.
2.Raisetherearofmachineandsupportitwithjack
stands(orequivalentsupport)justhighenoughto
allowthedrivewheelstoturnfreely.
3.Removetheelectricalconnectionfromtheseatsafety
switch,locatedunderthebottomcushionoftheseat.
Note:Theswitchisapartoftheseatassembly.
4.Temporarilyinstallajumperwireacrosstheterminals
intheconnectorofthemainwiringharness.
5.Starttheengine.
Note:Engagetheparkingbrakeandmovethe
motion-controlleversoutbeforestartingtheengine.
Youdonotneedtobeintheseatbecauseofthe
jumperwirebeingused.Runtheengineatfullthrottle
andreleasethebrake.
6.Runthemachineatleast5minuteswiththe
motion-controlleversatfullforwardspeedtobringthe
hydraulicoiluptooperatingtemperature.
7.Bringthemotion-controlleversintotheNEUTRAL
position.
8.Adjustthepump-controlrodlengthsbyrotatingthe
doublenutsontherodintheappropriatedirection
untilthewheelsslightlycreepinreverse(Figure87).
Figure87
1.Doublenuts
9.Movethemotion-controlleverstotheREVERSE
position,andwhileapplyingslightpressuretothelever,
allowthereverseindicatorspringstobringthelevers
backtoneutral.
Note:Thewheelsmuststopturningorslightlycreep
inreverse.
10.Shutoffthemachine.
11.Removethejumperwirefromwireharnessandplug
theconnectorintotheseatswitch.
12.Removethejackstands.
13.Raisethedeckandinstalltheheight-of-cutpin.
14.Checkthatthemachinedoesnotcreepinneutralwhen
youdisengagetheparkingbrakes.
55

Table of Contents

Related product manuals