Toro 74919TE User Manual

72 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FormNo.3400-138RevA

ZMaster

®

Professional6000

SeriesRidingMower

with132cmor152cmTURBOFORCE

®

Side

DischargeMower

ModelNo.74919TE—SerialNo.316000001andUp

ModelNo.74925TE—SerialNo.316000001andUp

g027403

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3400-138*A

Table of Contents

Questions and Answers:

C
Charles RasmussenSep 1, 2025
How to fix a starter that won't crank on my Toro 74919TE Lawn Mower?
- T
  timothy63Sep 1, 2025
  If the starter on your Toro Lawn Mower won't crank, check these items: * Ensure the blade-control switch is disengaged. * Engage the parking brake. * Move the motion-control levers to the NEUTRAL-LOCK position. * Make sure you are sitting in the operator’s seat. * Charge the battery if it's dead. * Check the electrical connections for good contact. * Replace the fuse if it's blown.
T
Thomas KellerAug 25, 2025
Why won't my Toro 74919TE Lawn Mower engine start?
- C
  Calvin RussellAug 25, 2025
  If your Toro Lawn Mower engine won't start, starts hard, or fails to keep running, try the following: * Fill the fuel tank. * Open the fuel shutoff valve. * Add oil to the crankcase. * Ensure that the throttle control is midway between the 'SLOW' and 'FAST' positions. * Replace the fuel filter. * Clean or replace the air cleaner element. * Check the seat switch indicator; replace the seat if needed. * Check the electrical connections for good contact; clean the connector terminals thoroughly with electrical contact cleaner, apply dielectric grease, and reconnect. * Clean, adjust, or replace the spark plug. * Check the spark plug wire connection.
C
Carlos ManningAug 25, 2025
How to fix a Toro 74919TE when the starter does not crank?
- C
  Curtis MaysAug 25, 2025
  If the starter on your Toro Lawn Mower doesn't crank, here are some things to check: 1. Move the blade control switch (PTO) to disengaged. 2. Set the parking brake. 3. Ensure that the drive levers are in the neutral lock position. 4. Sit on the seat. 5. Charge the battery. 6. Check the electrical connections for good contact. 7. Replace the fuse.
Z
zhernandezSep 5, 2025
What to do if my Toro Lawn Mower machine vibrates abnormally?
- C
  Connor Simpson Jr.Sep 5, 2025
  If your Toro Lawn Mower is vibrating abnormally, it could be due to: * Bent or unbalanced cutting blade(s); install new cutting blade(s). * A loose blade mounting bolt; tighten the blade mounting bolt. * Loose engine mounting bolts; tighten the engine mounting bolts. * A loose engine pulley, idler pulley, or blade pulley; tighten the appropriate pulley.
S
Sherri PowellSep 9, 2025
What to do if my Toro 74919TE Lawn Mower clutch does not engage?
- J
  Jacob TurnerSep 9, 2025
  If the clutch on your Toro Lawn Mower doesn't engage, it could be due to a blown fuse, low voltage supply at the clutch, a damaged coil, inadequate current supply, or a rotor/armature air gap that is too large. To address this, replace the fuse, check the coil resistance, battery charge, charging system, and wiring connections, and replace components if necessary; repair or replace the clutch lead wire or electrical system and clean the connector contacts; remove the shim or replace the clutch.
Y
yrobinsonSep 3, 2025
How to fix an uneven cutting height on my Toro 74919TE?
- T
  Tommy ReedSep 3, 2025
  To fix an uneven cutting height on your Toro Lawn Mower, start by sharpening any dull blades or replacing bent ones. Next, level the mower deck from side-to-side and front-to-rear. Clean the underside of the mower deck. Also, ensure the tire pressure is correct. If the blade spindle is bent, contact an Authorized Service Dealer.
D
David ShannonAug 30, 2025
How to fix uneven cutting height on Toro Lawn Mower?
- L
  Logan HooperAug 30, 2025
  To fix an uneven cutting height on your Toro Lawn Mower, start by sharpening any dull blades or installing new ones if bent. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower deck, adjust the tire pressure to the correct level. For a bent blade spindle, contact an Authorized Service Dealer.
T
Troy BrownSep 12, 2025
What to do if my Toro 74919TE does not drive?
- D
  denise10Sep 12, 2025
  If your Toro Lawn Mower doesn't drive, first check that the bypass valves are closed tight. If not, tighten them. Also, inspect the pump belt for wear, looseness, or breakage and change the belt if needed. Ensure the pump belt is correctly positioned on the pulley. Replace the spring if the idler spring is broken or missing. Finally, verify the hydraulic fluid level; add hydraulic fluid to the reservoirs if it is low, or let it cool down if it is too hot.
S
Samuel WilliamsSep 7, 2025
What causes abnormal vibrations in my Toro 74919TE?
- U
  unavarroSep 7, 2025
  If your Toro Lawn Mower vibrates abnormally, try the following: 1. Install new cutting blade(s). 2. Tighten the blade mounting bolt. 3. Tighten the engine mounting bolts. 4. Tighten the appropriate pulley.
C
christian48Aug 27, 2025
Why Toro 74919TE blades do not rotate?
- Y
  yjonesAug 27, 2025
  If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken mower deck belt; in this case, install a new deck belt. Another possibility is that the mower deck belt is off the pulley; reinstall it and check the idler pulley, idler arm, and spring for correct position and function. Also, check the pump drive belt for wear, looseness, or breakage, and adjust the belt tension or install a new belt. Finally, inspect the idler spring and replace it if it's broken or missing.

Toro 74919TE Specifications

General

Brand	Toro
Model	74919TE
Category	Lawn Mower
Language	English

Related product manuals

Preview: Toro 74915

Toro Z Master 74915

Preview: Toro 74915 Z Master G3

Toro 74915 Z Master G3

Preview: Toro 74950

Preview: Toro 74952