Toro 74947 - Controls System Maintenance; Adjusting the Control-Handle Position

To Next Page

To Previous Page

ControlsSystem

Maintenance

AdjustingtheControl-Handle

Position

Thereare2heightpositionsforthecontrollevers—highand

low .Removetheboltstoadjusttheheight.

1.Disengagetheblade-controlswitch(PTO),movethe

motion-controlleverstotheNEUTRAL-LOCKposition,

andsettheparkingbrake.

2.Stoptheengine,removethekey,andwaitforallmoving

partstostopbeforeleavingtheoperatingposition.

3.Loosentheboltsandangenutsinstalledinthelevers

(Figure80).

4.Aligntheleversinthefront-to-rearpositionbybringing

theleverstogethertotheNEUTRALposition,slidethem

untiltheyarealigned,andtightenthebolts(Figure81).

Figure80

1.Bolt

3.Controllever

2.Handle4.Nut

Figure81

5.Iftheendsofthelevershitagainsteachother,refer

toAdjustingtheMotion-ControlNeutral-LockPivot

(page59).

Other manuals for Toro 74947