Toro 78363 - Page 15

Installation
13
8. Press the button of the mid Attach–A–Matic
and twist the lever clockwise to release the
mower (Fig. 21).
m–3457
1
2
Figure 21
1. Mid Attach–A–Matic 
button
2. Mid Attach–A–Matic 
lever
9. Pull the two spring–loaded J–pins from the deck
lift arms and twist them slightly so that they stay
disengaged (Fig. 22).
m–3456
1
Figure 22
1. J–pin
10. If you wish to remove the pulley box, push the
latch release buttons on the front
Attach–A–Matic (Fig. 23) and raise the latch
levers to open the latches holding the pulley box.
Remove the pulley box.
m–3458
3
1
2
2
Figure 23
1. Front Attach–A–Matic 
button (one on each side)
2. Front Attach–A–Matic 
latches
3.
Pulley box
11. Start the tractor and raise the attachment lift to
provide ample clearance to slide out the mower.
Then turn the ignition key to “STOP” to stop the
engine. Remove the ignition key.
12. Slide the mower out from the driver’s right–hand
side of the tractor.
13. Replace the grille.