How to fix uneven cutting height on Toro 78395?
Uneven cutting height on your Toro Lawn Mower can be caused by a few things. First, check and set the tire pressure to the correct level. Next, make sure the mower is level from side-to-side and front-to-rear. Lastly, a dirty underside of the mower can also contribute to uneven cutting, so clean it thoroughly.
How to increase transport height on Toro 78395?
If you're experiencing insufficient transport height with your Toro Lawn Mower, the lift arm cams may be improperly adjusted. You should adjust the lift arm cams to correct this.
What to do if PTO belt keeps slipping on my Toro Lawn Mower?
If the PTO belt on your Toro Lawn Mower is slipping, coming off the pulleys, or failing, several factors could be responsible. Start by checking the belt tension and adjusting it as necessary. Ensure the mower level and blade slope in transport are correctly adjusted. Inspect the belt for wear or damage; if found, replace it with a new one. Always operate engine-powered attachments at full throttle. If the pulley is damaged, contact an Authorized Service Dealer.
What to do if blades don't rotate on my Toro 78395?
If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken blade drive belt, which requires replacement with a new one. It's also possible that the blade drive belt is off the pulley; in this case, reinstall the belt and inspect the idler pulley and belt guides for correct positioning. Another potential cause is a worn, loose, or broken PTO belt, which would also need to be replaced.
What to do if PTO belt comes off pulleys when cutting tall grass with my Toro 78395 Lawn Mower?
If the PTO belt comes off the pulleys, slips, or fails when using your Toro Lawn Mower, especially in tall grass, consider these points: avoid engaging the PTO in tall uncut grass; instead, engage it only in shorter or previously cut grass. If you're cutting tall grass or weeds, set the mower to its highest position for the first pass, then make a second pass at your desired height. Ensure the cutter mower isn't clogged with grass clippings by cleaning it regularly. Also, reduce your ground speed to prevent overloading the mower.
Details the location and importance of safety decals and instructions on the mower.
Guidance on physically attaching the mower deck to the tractor using the lift system.
Procedure for correctly aligning and securing the mower deck to the tractor's attachment lift arm.
Instructions for setting the cutting height and ensuring the mower deck is properly leveled.
Instructions for engaging and disengaging the PTO to power the mower's electric clutch.
Instructions for inspecting, removing, and replacing mower cutting blades for optimal cut quality.
General| Model | 78395 |
|---|---|
| Power Source | Gasoline |
| Engine Displacement | 159 cc |
| Self-Propelled | Yes |
| Drive System | Rear-Wheel Drive |
| Walk Behind | Yes |
| Type | Walk-Behind Mower |
| Cutting Width | 22 inches |
| Cutting Height | 1 inch to 4 inches |
| Oil Capacity | 20 oz (0.6 L) |
To Next Page
