Toro 78395 - Attachment Lift Lever

Operation
17
Attachment Lift Lever
The attachment lift lever (Fig. 30 & 31) is used to
raise and lower various attachments.
Raising Attachments
1. Start the tractor.
2. Pull the attachment lift lever upward until the
latch locks. In this position, the lift will hold the
attachment in the up, or raised position.
POTENTIAL HAZARD
• When the engine is off, attachments in the
raised position can gradually lower.
WHAT CAN HAPPEN
• Someone nearby may be pinned or injured
by the attachment as it lowers.
HOW TO AV
OID THE HAZARD
• Always lower the attachment lift each time
you shut off the tractor.
Lowering Attachments
1. Start the tractor.
2. Push the attachment lift lever downward to
lower the attachment.
m–3258
1
Figure 30
1. Attachment lift lever
m–3315
1
2
Figure 31
1. Raise attachment 2. Lower attachment
Adjusting the T wo Front
Wheels
The two front adjustable wheels must be adjusted in
the proper hole location for each time you change
deck height-of-cut position.
IMPORTANT: For cutting, the wheels should
be oriented as shown (Fig. 32), parallel to the
tractor . Only turn the wheels parallel to the
cutter deck for installation or removal.
1. After selecting height of cut, make sure the front
adjustable wheels are approximately 3/8” (1 cm)
off the ground.