Toro Dingo 323 - Setup; Loose Parts; Installing the Valve Lever; Charging the Battery

7
AdjustingtheParking
Brake
NoPartsRequired
Procedure
1.Pushtheparking-brakeleverupandforwardto
disengageit.
2.Checkthebrakebarsprotrudingfromeitherside
ofthemachine.
Note:Thebarsshouldbeabout3mm(1/8
inch)fromthewheelhubandneitherbarshould
beabletomovesidetoside.
3.Pulltheparking-brakeleverdowntoengageit.
Note:Thebarsshouldslideintothenotches
inthewheelhub.
4.Ifthebrakebarsmove,aretooclosetothe
wheelwhendisengaged,ordonotfullyengage
theslotsinthewheelhubwhenengaged,
correctitbyadjustingthe2adjustmentnutson
thecable(Figure12).
8
InstallingtheLoader-Valve
Lock
Partsneededforthisprocedure:
1Loader-valvelockassembly
2
Self-tappingbolts(1/4x5/8inch)
1
Bolt(1/4x2inches)
1
Spacer
Procedure
1.Using2self-tappingbolts(1/4x5/8inch),
looselyinstalltheloader-valvelockbehindthe
controllevers(Figure18).
Note:Theloadervalvelockshouldbeableto
slideforwardandbackwardintheslots.
g003566
Figure18
1.Loader-valvelock
2.Self-tappingbolts(1/4x
5/8inch)
2.Removetheboltsecuringtheleftleverand
replaceitwiththebolt(1/4x2inches)andthe
spacer(Figure19).
g003597
Figure19
1.Bolt(1/4x2inches)2.Spacer
9