Toro e-cycler 20360 - Adjusting the Cutting Height; Stopping the Machine

Figure9
Note:Keepthemachinerunningwhenturningthe
machine.Turningthemachineoffwhenmakingaturn
doesnotsavebatteryenergy.
StoppingtheMachine
1.Releasethecontrollever.
WARNING
Whenthekeyisintheplugreceptacle,themachine
isoperational.Someonecouldaccidentallystart
themachineandseriouslyinjureyouorother
bystanders.
Alwaysremovethekeyfromtheplugreceptacle
whenleavingthemachineunattended,evenfor
ashortperiodoftime.
2.Removethekeyfromtheplugreceptacleifthemachinewill
beunattendedforanyperiodoftime.
Note:Storethekeyinaplaceoutofthereachof
children.
3.Chargethebattery.
Important:Alwayschargethebatteryimmediately
afterusingthemachine.Ifyoudonotchargethe
batteryaftereachuse,youwillshortenthebattery
life.See2ChargingtheBattery(page5).
AdjustingtheCuttingHeight
WARNING
Adjustingthecuttingheightmaybringyouintocontact
withthemovingblade,causingseriousinjury.
•Stoptheengineandwaitforallmovingpartsto
stop.
•Donotputyourngersunderthehousingwhen
adjustingthecuttingheight.
Adjustthecuttingheightasdesired.Setall4wheelstothesame
height(Figure10).
Note:Movethecutting-heightleversforwardtoraisethe
machine;movethecutting-heightleversrearwardtolower
themachine.
Figure10
1.Frontcutting-heightlever
(2)
2.Rearcutting-heightlever
(2)
Note:Thecutting-heightsettingsare25mm(1inch);38mm
(1-1/2inches);51mm(2inches);64mm(2-1/2inches);76
mm(3inches);89mm(3-1/2inches);and102mm(4inches).
8