EasyManua.ls Logo

Toro eTimeCutter 75841 - Side Discharge; Adjusting the Height of Cut

Toro eTimeCutter 75841
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Side Discharge
The hinged grass deflector disperses clippings to the side and down toward the turf.
DANGER
Without the grass deflector, discharge cover, or complete grass catcher assembly
mounted in place, you and bystanders are exposed to blade contact and thrown
debris. Contact with rotating mower blade(s) and thrown debris will cause injury or
death.
Do not remove the grass deflector from the machine, because the grass deflector
routes material down toward the turf. If the grass deflector is ever damaged,
replace it immediately.
Never put your hands or feet under the mower.
Never try to clear the discharge area or mower blades unless the power takeoff
(PTO) is off. Rotate the key to the O
FF position and remove the key.
Adjusting the Height of Cut
Use the height-of-cut lever to the right of the operating position to adjust the height of cut
from 38 to 114 mm (1-1/2 to 4-1/2 inches) in 13 mm (1/2 inch) increments.
Note: The transport position is the highest height-of-cut position.
G441492
3463-565A Page 4–13 Operation: During Operation

Table of Contents