Toro Greensmaster
Flex 18 04018 - Page 113

Greensmaster Flex 18/21 GroomerPage 8 – 17
Disassembly (Fig. 17)
1. Remove groomer arm from cutting unit (Fig. 18):
A. Loosen cap screw that secures front roller to
groomer arm.
B. Remove lock nut and spring washer that secure
groomer lift rod to cutting unit side plate.
C. Remove lock nut and HOC washer that secure
groomer arm to cutting unit side plate.
D. Slide groomer arm from front roller and cutting
unit.
2. Disassemble groomer arm using Figure 17 as a
guide.
NOTE: Right and left side HOC groomer arms and lift
arm assemblies are different; other components shown
in Figure 17 are the same on both sides of machine.
NOTE: Grooved pin (item 3) is used to retain lock screw
(item 6) to lift arm assembly.
Assembly (Fig. 17)
1. Apply antiseize lubricant to threads of groomer lift
rod (item 5) and lift arm assembly (item 8). Assemble
groomer arm using Figure 17 as a guide.
2. Install groomer arm onto cutting unit (Fig. 18):
A. Slide groomer arm onto front roller shaft and to
cutting unit.
B. Secure groomer arm to cutting unit side plate with
HOC washer and lock nut.
C. Secure groomer lift rod to cutting unit side plate
with spring washer and lock nut.
D. Make sure that front roller is centered to cutting
unit. Secure front roller to groomer arm with cap
screw.
3. Check height–of–cut and adjust as needed.
1. HOC screw
2. Groomer sideplate
3. Spring washer
4. Lock nut
5. Lock nut
6. HOC washer
7. Groomer arm
8. Plow bolt
Figure 18
2
3
4
5
6
7
8
1
1. LH groomer side plate
2. Lock nut/spring washer
3. LH groomer arm
Figure 19
2
3
1
Groomer