Greensmaster Flex 18/21Groomer Page 8 – 18
Grooming Brush
Figure 20
1. Grooming brush shaft
2. Lock nut
3. J–bolt 4. Grooming brush
3
1
2
4
2
3
20 to 25 in–lb
(2.3 to 2.8 N–m)
20 to 25 in–lb
(2.3 to 2.8 N–m)
The grooming brush attaches to the groomer drive in
place of the grooming reel. Removal and installation of
the grooming brush use the same procedure as removal
and installation of the grooming reel (see Grooming
Reel in this section).
To remove the grooming brush from the shaft, remove
the lock nut and J–bolt from both ends of the brush.
While retaining the shaft, rotate the brush and slide from
the shaft. When assembling the brush to the shaft, se-
cure the assembly with J–bolts and lock nuts. Make sure
that the J–bolts are installed with the threaded portion
on the outside of the brush (Fig. 21). Torque lock nuts
from 20 to 25 in–lb (2.3 to 2.8 N–m).
1. J–bolt 2. Lock nut
Figure 21
2
1
To Previous Page
Loading...
