Toro Greensmaster Flex 21 - Groomer Reel

Greensmaster Flex 21Groomer (Model 04204) (Rev. B) Page 9 – 8
Groomer Reel
Figure 6
1. Lock nut
2. Groomer belt cover
3. Groomer belt
4. Drive pulley (LH thread)
5. RH groomer arm assembly
6. Spring
7. Lock nut (2 used)
8. RH side plate
9. Side plate adapter (2 used)
10. Groomer shim
11. Oil seal
12. Cutting reel assembly
13. Height–of–cut screw (2 used)
14. Spacer
15. LH groomer arm assembly
16. Height of cut washer (2 used)
17. Lock nut (2 used)
18. Cap screw (2 used)
19. LH side plate
20. Flange nut
21. Grease fitting
22. Cap plug
23. Carriage bolt (2 used)
24. Groomer reel assembly
25. Plow bolt (2 used)
26. Front roller
27. Lock nut (2 used)
28. Spring washer (2 used)
29. Bushing (2 used)
30. Square key
31. Driven pulley
FRONT
RIGHT
100 to 120 in–lb
(11.3 to 13.6 N–m)
3
5
2
4
1
6
7
9
8
14
16
12
15
10
11
13
17
19
18
20
21
22
23
25
24
26
27
28
31
29
18
30
20
Threadlocking
Compound
100 to 120 in–lb
(11.3 to 13.6 N–m)
Remove the groomer reel to reverse the shaft, replace
individual blades or replace the shaft. The shaft can be
reversed so that the sharpest edge of the groomer
blades are forward.
Removal
1. Park mower on a level surface. Make sure engine is
OFF. Remove high tension lead from the spark plug.
2. Remove groomer belt cover and groomer belt from
right side of mower (see Groomer Belt Replacement in
this section).
3. Loosen cap screws that secure front roller shaft to
RH and LH groomer arms (Figs. 7 and 8).
4. Remove lock nut (item 27) and spring washer (item
28) that secure RH groomer arm lift rod to RH side plate
(Fig. 7).
5. Remove lock nut (item 17), washer (item 16) and car-
riage bolt (item 23) that secure RH groomer arm assem-
bly to RH side plate. Do not change height–of–cut screw
adjustment. Remove RH groomer arm assembly.
6. Pull front roller assembly out of LH groomer arm and
remove from mower.
NOTE: To prevent groomer shaft from turning when re-
moving driven pulley, use wrench on shaft flats to hold
shaft.
7. Remove the flange nut that secures driven pulley
(item 31) to groomer shaft. Remove driven pulley from
shaft. Locate and retrieve square key (item 30) that lo-
cates pulley on shaft.