Toro Greensmaster Flex 21 - Throttle Cable Replacement

Greensmaster Flex 21
Page 6 – 9
Chassis and Controls
Throttle Cable Replacement
Removal
1. Park mower on a level surface. Make sure engine is
OFF. Remove high tension lead from the spark plug.
2. Remove cable tie that secures throttle cable.
3. Remove throttle cable from the engine governor link-
age as follows (Fig. 11):
A. Unscrew throttle cable screw enough to release
the throttle cable from the nut in the governor lever.
B. Remove cap screw and flange nut that locate
cable clamp to traction unit frame (Fig. 12).
C. Pull throttle cable clear of the nut in the governor
lever.
4. Remove four screws securing the console to the
handle and move console forward and away from the
handle.
5. Remove throttle cable from the throttle lever assem-
bly (Fig. 13):
A. Unsnap the cable housing from the control brack-
et.
B. Unhook cable end from throttle lever.
6. Remove throttle cable from the mower.
Installation
1. Connect throttle cable to the throttle lever. Snap
throttle cable housing to the control bracket (Fig. 13).
2. Position console to handle and secure console with
four screws.
3. Route throttle cable to the governor lever.
4. Install cable to the governor lever as follows (Fig. 11):
A. Insert throttle cable into the nut.
B. Tighten throttle cable screw to hold cable in the
nut. Do not fully tighten screw.
C. Install and secure cap screw and flange nut that
locates cable clamp to frame and engine base.
5. Adjust throttle cable (see Throttle Linkage Adjust-
ment in Chapter 3 – Engine).
6. Secure throttle cable with cable tie.
Figure 11
1. Governor lever
2. Throttle cable
3. Throttle cable screw
4. Throttle cable nut
1
3
2
4
1. Throttle cable 2. Cable clamp
Figure 12
2
1
1. Handle
2. Throttle cable
3. Throttle lever
4. Control bracket
5. Console
Figure 13
1
3
2
FRONT
RIGHT
4
5
Chassis and
Controls