Greensmaster Flex 21Page 7 – 14Cutting Unit (Rev. C)
Service and Repairs
Backlapping
1. Park mower on a level surface. Make sure engine is
OFF. Remove high tension lead from the spark plug.
2. Make sure reel drive lever is DISENGAGED.
3. Remove plug from the reel drive cover on the left side
of the reel assembly (Fig. 21).
4. Insert a 18 mm socket onto hex flange nut on left side
of reel shaft.
DANGER
Contact with the reel or other moving parts can
result in personal injury.
Stay away from the reel when backlapping.
Never use a short handled paint brush for
applying lapping compound. Part No.
TOR299100 backlapping brush assembly
(complete or individual components) is
available from your local Authorized Toro
Distributor.
5. Backlap according to procedure in TORO Sharpen-
ing Reel and Rotary Mowers Manual, Form No. 80300
SL.
NOTE: For a better cutting edge, run a file across the
front face of the bedknife when the lapping operation is
completed. This will remove any burrs or rough edges
that may have built up on the cutting edge.
6. Reinstall plug when backlapping operation is com-
pleted.
1. Cover plug
Figure 21
1
To Next Page
Loading...
