11. Slide a new retaining ring on the axle shaft and
support the shaft and ring in a suitable press (Fig. 14).
Press the retaining ring firmly against the bearing.
Figure 14
12. Put a light coating of No. 1 Permatex on the outside
diameter of a new grease seal (surface that contacts the
axle housing). Install the new seal to a depth of 1.218
in. into the housing (Fig. 15, 16). After the seal has been
assembled, put grease on the lip of the seal.
Figure 15
l1.218" sea
installation depth
Figure 16
Groundsmaster
®
220-D/223-D Page 6 - 7 Repairs
To Next Page
Loading...
