Roller Adjustment
Note: If cutting unit is to be used in the 1” or 1–1/2”
height–of–cut setting, cutting unit rollers must be reposi-
tioned in the top bracket holes.
To adjust front and rear rollers:
1. Remove cotter pins securing roller shafts to under-
side of deck.
2. Slide shafts out of lower bracket holes, align rollers
with top holes and install shafts.
3. Install cotter pins to secure assemblies.
Skid Adjustment
Adjust skids by removing flange nuts, positioning skids
at desired position and reinstalling flange nuts.
1
Figure 3
1. Skid
Guardian 62 Recycler Cutting Unit
Page 15 – 6
Rev. B
Groundsmaster 223–D
To Next Page
Loading...
