Adjustments
Rear Wheel Toe-in
1. Measure center–to–center distance (at axle height)
at front and rear of steering tires. Front measurement
must be 1/8 in. less than rear measurement.
2. To adjust, loosen clamps at both ends of tie rod.
3. Rotate tie rod to move front of tire inward or outward.
4. Tighten tie rod clamps when adjustment is correct.
1
Figure 6
1. Tie rod
Steering Stop
The rear axle steering stops help prevent over travel of
the steering cylinder in case of impact on rear wheels.
The stops should be adjusted so there is 0.090 in.
clearance between bolt head and knuckle on axle when
steering wheel is completely turned left or right.
1. Thread bolt in out out unitl 0.090 in. clearance is
at
tained (Fig. 7)
Figure 7
1. Tie rod
Adjustments Page 14 - 4
Rev. B
Groundsmaster
®
223-D
To Next Page
Loading...
