Toro Groundsmaster 220-D - Specifications; Adjustments; Service and Repairs

Specifications
Item Specification
Wheel lug nut torque (font and rear) 45–55 ft-lbs. (61 to 75 Nm)
Rear wheel toe-in 0.000 to 0.125 in. (0.0 to 3.0 mm)
Tire pressure (front and rear) 20 psi (138 kPa)
Axle lubricant SAE GL-5 80W90 gear lube
Bi–directional clutch lubricant Mobil 424 hydraulic fluid
Adjustments
Steering Stop Bolt Adjustment
The rear axle steering stop bolts help prevent over–trav-
el of the steering cylinder in case of impacts on rear
wheels. When the steering cylinder is fully extended, a
gap of 1/16” (1.6 mm) should exist between left side bev-
el gear case casting and stop bolt (Fig. 1). When the
steering cylinder is fully retracted, a gap of 1/16” (1.6
mm) should exist between right side bevel gear case
casting and stop bolt.
1
2
Figure 1
1. Steering stop bolt 2. Bevel gear case (LH)
Service and Repairs
See Operators Manual for Maintenance intervals and instructions.
4WD Rear Axle Page 10.1 – 2 Groundsmaster 228–D
(Groundsmaster 228–D with Dae Dong axle)
Rev. H