Toro Groundsmaster 3320-D

Other manuals for Toro Groundsmaster 3320-D

Questions and Answers:

M
Mitchell HopkinsSep 14, 2025
Why is the traction jerky when starting Toro Lawn and Garden Equipment?
- A
  Antonio TaylorSep 14, 2025
  If the traction on your Toro Lawn and Garden Equipment feels jerky when starting, it might be due to a friction wheel on the traction pedal that is out of adjustment or worn; adjust or replace it. Another cause could be a misadjusted, disconnected, binding, or damaged traction control linkage; adjust, reconnect, or repair it. Also, a hydrostat check valve that is not seating or is damaged may be the reason; repair or replace it.
A
amycoleSep 15, 2025
Why is neutral difficult to find on Toro Lawn and Garden Equipment?
- C
  Casey MartinezSep 15, 2025
  If you find neutral difficult to find or the unit only operates in one direction on your Toro Lawn and Garden Equipment, the traction control linkage may be misadjusted, disconnected, binding, or damaged; adjust, reconnect, or repair it. A hydrostat check valve that isn't seating properly or is damaged could also be the cause; repair or replace it. Additionally, the hydrostat itself might be worn or damaged; in that case, repair or replace it.
C
cgomezSep 17, 2025
Why is hydraulic fluid foaming in my Toro Lawn and Garden Equipment?
- J
  jacoblambSep 18, 2025
  If the hydraulic fluid in your Toro Lawn and Garden Equipment is foaming, it could be due to a low oil level in the reservoir (front axle); fill it to the proper level. Alternatively, the hydraulic system might contain the wrong type of oil; change to the correct type. Another possible cause is an air leak in the pump suction line; locate and fix the leak.
C
Craig VelazquezSep 19, 2025
Why is traction response sluggish on Toro Lawn and Garden Equipment?
- B
  Bruce JacobsSep 19, 2025
  If the traction response of your Toro Lawn and Garden Equipment is sluggish, it could be due to low charge pressure; increase it. Very cold hydraulic oil can also cause this issue; allow the oil to warm up. Other potential causes include a hydrostat check valve that is not seating or is damaged (repair or replace it), brakes that are not released (release them), or a worn or damaged hydrostat (repair or replace it).