Rev. A
Groundsmaster 7200/7210Hydraulic System Page 4 - 90
Lift Control Manifold Service (Serial Number Above 313000000)
1. Lift control manifold
2. Zero leak plug with O- ring
3. Solenoid valve (raise)
4. Solenoid valve (lower)
5. Solenoid coil
6. Coil spacer
7. Nut
8. Nut
9. Expander plug (non- serviceable)
10. Solenoid coil
Figure 104
2
3
8
1
7
5
20 ft- lb
(27 N- m)
60 in- lb
(6.7 N- m)
25 ft- lb
(34 N- m)
20 ft- lb
(27 N- m)
SERIAL NUMBER
ABOVE 315000000
SERIAL NUMBER
FROM 313000000
TO 314999999
2
3
6
8
1
7
4
5
5
4
10
9
20 ft- lb
(27 N- m)
60 in- lb
(6.7 N- m)
25 ft- lb
(34 N- m)
20 ft- lb
(27 N- m)
The lift control manifold on machines with a serial num-
ber from 313000001 to 314999999 is different than the
manifold used on machines with a serial number above
315000000. Both manifolds are shown in Figure 1 04.
Service for manifold valves, solenoid coils and plugs are
similar on either manifold.
NOTE: The ports on the lift control manifold are marked
for easy identification of components. See Hydraulic
Schematic in Chapter 8 - Foldout Drawings to identify
the function of the hydraulic lines and cartridge valves
at each manifold port.
NOTE: The lift control manifold u sed on machines with
a serial number from 313000001 to 314999999 has an
expander plug (item 9) installed in manifold port 4. This
plug is not a serviceable part and is used to prevent hy-
draulic flow from manifold port 1 to port 4.
NOTE: If the lift control manifold was replaced for some
reason on a machine with a serial number from
313000001 to 314999999, the replacement manifold
may have been the same manifold as used on machines
with a serial number above 315000000.
To Next Page
Loading...
