IV. Manual Operation
Manual Program Cycle
Use this feature to manually start your normal program cycle at any time. Each valve’s run
time will be operated for the program selected. For example, this can be used to start a
program an extra time on a particularly hot day.
1. Set the dial to the Manual Program Cycle position.
2. Select program A, B, or C.
3. Press the + button to select Manual Program Cycle watering.
4. Press the Next button until the desired starting valve is displayed. That valve and all
subsequent valves in the selected program will water in sequence.
5. Turn the dial to Run position. The timer will complete the manual watering cycle and then
revert to automatic operation.
6. The display will periodically show the valve number and will count down the run time for
each active valve.
7. If desired, you may turn the dial to the Off position for longer than three seconds to
discontinue manual watering. Always return dial to the Run position to enable automatic
watering.
10
To Next Page
Loading...
