1. To select your master valve option ON, set the dial to Zone Run Time.
2. Press the Next button until Master is displayed (after the last valve).
3. Press the + button to turn the master valve ON.
4. Press the – button to turn the master valve OFF.
Selecting Program Start Times
This sets the time of the day you wish to water. Each program has three start times available.
1. Set the dial to the Start Time position. The display will flash “START A1, START B1,
or START C1” depending on the position of the program select switch, and then show
the start time programmed. If there is no start time entered, OFF will be displayed.
2. Select program A, B, or C.
3. Use the + and – buttons to change the start time.
4. Press the Next button to select the next start time.
5. Repeat steps 3 and 4 for subsequent start times, when watering is needed more than one
time per day.
6. If a start time is not required, set the start time to between 11:59 p.m. and 12:00 a.m.
to set a start time to OFF. Return dial to Run position.
6
To Next Page
Loading...
