Special Features
This position has three functions. In this position, you may Erase all programmed information,
Review all Programmed information, or activate a Rain Sensor.
Program Review
You can review the contents of programs A, B, and C by setting the dial to the Special
Features position. The display will show “Review”. Pressing the + button will begin the
program review. The display will scroll through the contents of the selected program. The items
displayed include the seasonal adjustment %, the start times selected, the valves selected, the
valve run times, and the active watering days. By moving the program selector switch, each
program can be reviewed in turn. You can press and hold the + button to speed up the review
and the – button to slow down the review.
Erase Program Information
Use this to erase program information.
Note: When new from the factory, a default program has been installed in program A to
water all valves for 10 minutes every day at 4:00 a.m.
1. Set the dial to Special Features.
2. Select Program A, B, or C using the program selection switch.
3. Press the Next button until Erase is displayed.
4. Press the + button and display will show Confirm.
5. Press the + button again, and the display will show Done.
6. The program is completely blank, allowing you to program Lawn Master using the
instructions on the previous pages.
13
To Next Page
Loading...
