48
CONSOLE (FIG. 1):
1. INDIVIDUAL BOOM VALVES: Allows
individual selection of Boom sections and controls
the flow of spray solution to left, center, and right
Booms and works in series with Master Boom
Valve. When the lever is in the down position the
Boom Section Valve is on. When "OFF", flow is
directed back to the tank.
2. PRESSURE CONTROL VALVE: Determines
application rate by regulating amount of fluid that
is bypassed to tank or pump suction. Turn
clockwise to INCREASE or counter clockwise to
DECREASE spraying pressure and application
rate to the desired level.
3. MASTER BOOM VALVE: Directs spray flow
to Flowmeter and Individual Boom Valves in "ON"
position and to agitation in "OFF" position.
4. BOOM BYPASS VALVES: Manual adjustment
to equalize restriction of the particular Boom
Section when a section is turned "OFF." See FIG.
1.
CONTROLS AND OPERATION
104-8882
FIG. 2
FIG. 1
1. Individual Boom Valves 2. Pressure Control Valve
3. Master Boom Valve 4. Boom Bypass Valve
2
1880-1200
FIG. 3
1879-1200
1
2
1. Flowmeter 2. Indicator Light
5. PUMP ON/OFF SWITCH: Move to "ON"
position to engage the Diaphragm Pump. Move
to "OFF" position to disengage Diaphragm Pump.
See FIG. 2 on this page and Operating
Instructions, page 22.
6. FLOWMETER: Measures amount of fluid
flowing to Boom Control Valves. See FIG. 3.
3
1
4
104-8749
"OFF" Position
To Next Page
Loading...
