Toro Multi Pro 1250 - Page 16

16
1. Press in Ring on the Coupler and disconnect
tubing at the Gauge and Pressure Tee. Remove
Plug from Flowmeter and Coupler from Tee.
2. Apply thread Sealer to Coupler and Plug.
Secure Coupler into Flowmeter and Plug into Tee.
See Figures 1 - 5.
3. Connect the new longer Tubing by inserting
Tubing firmly into the Coupler at Flowmeter and
Coupler at Gauge. See Figures 4-5. The
assembly is complete.
FIG. 2
FIG. 4
FIG. 3
FIG. 1
Plug
Flowmeter
Ring
Coupler
Flowmeter
Tubing
Tubing
Pressure Tee
PressureTee
Gauge
Coupler
FIG. 5
Gauge
Plug
Tubing
Pressure Tee
PRESSURE TAP RELOCATION:
SETUP INSTRUCTIONS