Toro Power Max 826 OE - Installing the Traction-Control Linkage

2
InstallingtheTraction-Control
Linkage
Partsneededforthisprocedure:
2Hairpincotter
3Flatwasher
Procedure
1.Insertthelowerendoftherodintothelowerlinkarm
sothatthebentendofthespeed-controlrodfaces
rearward(Figure5).
g019004
Figure5
2.Securethelowerendofthespeed-controlrodwitha
atwasherandahairpincotter(Figure5).
3.Placeaatwasheronthetrunnion(Figure6).
Figure6
1.Speed-selectorlever
3.Innerwasher
2.Trunnion
4.Outerwasher
4.Shiftthespeed-selectorleverintoPositionR2.
5.Rotatethelowerlinkarmfullyupward
(counterclockwise)asshowninFigure7.
g019378
Figure7
6.Pulluponthespeed-controlrodandinsertthe
trunnionintotheholeinthespeed-selectorlever
(Figure6).
Note:Ifthetrunniondoesnottintothehole
whenyouliftuponthespeed-controlrod,rotatethe
trunnionupwardordownwardonthespeed-control
roduntilitts.
7.Securethetrunnionandupperendofthespeed-control
rodwithawasherandahairpincotter.
Note:Foreasierinstallation,lookdownthroughthe
openinginthespeedselector(Figure8).
Figure8
1.Speedselector
6