Toro power max 828 OE - Replacing the Drive Belts; Replacing the Headlight Bulb

12.Alignthetabonthechokecontrolknobwiththe
slotontheuppersnowhood.
13.Connectthechokecontrolknobtothechokeshaft
onthecarburetor.
AdjustingtheDischargeChute
Latch
Ifthedischargechutedoesnotlockintothedesired
positionordoesnotunlocksothatyoucanmoveitto
anotherposition,adjustthedischargechutelatch.
1.Removethefasteneronthegearcover(Figure47),
liftthefrontofthecoverup,andslideitbackand
outoftheway.
Figure47
2.Loosentheboltonthecableclamp(Figure48).
Figure48
1.Cableconduit2.Cableclamp
3.Graspthecableconduitandmoveittowardthefront
ofthemachineuntilthedischargechutelatchfully
engagesthegearteeth(Figure48andFigure49).
Figure49
1.Dischargechutelatch
2.Gearteeth
Note:Thelatchisspringloadedandwillnaturally
moveintotheteethofthegear(Figure49).
4.Removeanyslackinthecablebypullingthecable
conduitrearward.
5.Tightentheboltonthecableclamp.
6.Installandsecurethegearcover.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetractiondrivebelt
becomesworn,oil-soaked,orotherwisedamaged,go
towww.Toro.comforadditionalserviceinformationor
haveanAuthorizedServiceDealerreplacethebelt.
ReplacingtheHeadlightBulb
UseaGE89216Whalogenlightbulb.Donottouch
thebulbwithyourhandsorallowdirtormoistureto
comeintocontactwiththebulb.
1.Removethewireconnectorfromthebackofthe
headlight(Figure50).
Figure50
2.Turnthebaseofthebulbcounterclockwiseuntilit
stops(Figure51).
22