ProForce Debris Blower
Page 4 − 2
Electrical System
General Information
This Chapter gives information about troubleshooting,
testing and repair of the electrical system used in the
ProForce Debris Blower.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your ProForce Debris Blower machine. Re-
fer to the Operator’s Manual for additional information
when servicing the machine.
Electrical Power
Electrical power to ProForce Debris Blower compo-
nents is controlled by the Remote Control Module. To
make sure that machine operation does not occur unex-
pectedly, disconnect the negative battery cable from the
battery before performing any machine service.
Reattach the disconnected negative battery cable as
the last step in any repair. Secure cable with flange nut.
Torque nut from from 10 to 15 ft−lb (14 to 20 N−m).
Electrical Diagrams
The electrical schematic and wire harness drawings for
the ProForce Debris Blower are located in Chapter 7 −
Electrical Diagrams.
To Next Page
Loading...
