Adjusting the Cutting Height
Stop the engine and wait for all moving parts to stop.
Do not put your fingers under the housing when adjusting the cutting height.
If the engine has been running, the muffler will be hot and can severely burn you. Keep away fi'om the hot
muffler.
Adiust tile cutting height as desired. Set all four wheels to tile same height.
Note: Onh a front cutting height lever is shown.
2in 3-1/2in
2_3/8in 3.7/8iq 4"1/41n
1-5/8in
FRONT ml_ --_
G002882
Figure 13
Adjusting the Handle Height
Squeeze tile bottom of tile handle halves together and
change the handle holes in wifich the pins are motmted,
as shown in Figure i4.
Starting the Engine
1. Firml? push in tile primer 3 thnes with xour tlmmb,
holding tile primer in for a second before releasing it
each time (Figure 15).
Figure 14
1. Pin
Use this hole to raise the
handle
3. Use this hole to lower the
handle
2.
3X
G002581
Figure 15
Note: If tile air temperature is below 55°F (13°C),
firml? push tile primer in 5 times.
Hold tile blade control bar (Figure 16) against tile
handle.