After Operation
After Operation Safety
General Safety
• Always shut of f the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
• Clean grass and debris from the machine to help
prevent res. Clean up oil or fuel spills.
• Never store the machine or fuel container where
there is an open ame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
• Use care when loading or unloading the machine.
• Secure the machine from rolling.
Cleaning Under the
Machine
Service Interval : After each use
For best results, clean under the machine shortly after
you have completed mowing.
Cleaning Under the Machine in the
Operating Position
1. Lower the machine to its lowest cutting-height
setting.
2. Move the machine onto a paved level surface.
3. With the engine running and the blade engaged,
spray a stream of water in front of the right , rear
wheel ( Figure 18 ).
Note: The water will splash into the path of the
blade, cleaning out the clippings.
g002600
Figure 18
4. When no more clippings come out, stop the
water and move the machine to a dry area.
5. Start the engine and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
6. Shut of f the engine, remove the electric-start
button (if equipped), and allow the machine to
cool before storing it in an enclosed area.
Cleaning under the Machine in the
V ertical-stow Position
1. Set the machine in the vertical-stow position;
refer to Storing the Machine in the V ertical-Stow
Position ( page 18 ) .
2. W ash out the clippings from under the machine.
16
To Next Page
Loading...
