Reelmaster 3550--D/3555--D/3575--D
DPA Cutting Uni ts
Page 7 -- 1 1
Factor Possible Problem/Correction
Reel and bedknife sharpness
NOTE: After grinding the reel and/or bedknife, check
the reel to bedknife contact again after cutting two (2)
fairways. During this initial use, any burrs will be
removed from reel and bedknife which may create
improper reel to bedknife clearance and thus
accelerate wear. This practice of re--checking the reel
to bedknife contact after grinding will extend the
longevity of the sharpness of the edge of the reel and
the bedknife.
A reel and/or bedknife that has rounded cutting edges
or “rifling” (grooved or wavy appearance) cannot be
corrected by tightening the bedknife to r eel contact.
Grind cutting reel to remove taper and/or rifling. Grind
bedknife to sharpen and/or remove rifling.
Themostcommoncauseofriflingisbedknifetoreel
contact that is too tight.
Dull cutting edges must be corrected by grinding the
bedknife and cutting reel (see Bedknife Replacement
and Grinding and Preparing Reel for Grinding in the
Service and Repairs section of this chapter).
A new bedknife must be ground flat (within 0.002”)
after installation to the bedbar. Backlapping may
be required to properly mate the reel and bedknife
after installation into t he cutting unit.
NOTE: On cutting units equipped with optional
bedknives, slightly dull cutting edges may be corrected
by backlapping (see Backlapping in the Traction Unit
Operator’s Manual).
Rear roller adjustment Adjust the rear roller brackets to correct position
depending on the height--of--cut range and
aggressiveness of cut that is desired.
See Rear Roller Adjustment in the Cutting Unit
Operator’s Manual.
Height--of--cut “Effective” or actual height--of--cut depends on the
cutting unit weight and turf conditions. Effective
height--of--cut will be different from the bench set
height--of--cut.
See Height--of--Cut Adjustment in the Cutting Unit
Operator’s Manual.
Proper bedknife selection for height --of--cut desired If the bedknife is incorrect for effective height--of--cut,
poor quality of cut will result.
See Cutting Unit Operator’s Manual for bedknife
options.
Stability of bedbar Make sure bedbar pivot bolts are seated securely.
Check condition of the bushings in the side plates.
See Bedbar Removal and Installation in the Cutting
Unit Operator’s Manual.
Number of reel blades Use correct number of reel blades for clip frequency
and optimum height--of--cut range.
Refer to Clip Chart in Traction Unit Operator’s Manual.
DPA C utting
Units
To Next Page
Loading...
