Toro Reelmaster 5210 - Adjusting the Throttle

Figure62
1.Oillter
4.Applyalightcoatofcleanoiltothenewlterseal.
5.Installthereplacementoilltertothelteradapter.
Turntheoillterclockwiseuntiltherubbergasket
contactsthelteradapter,thentightenthelteran
additional1/2turn.
Important:Donotover-tightenthelter.
6.Addoiltothecrankcase;refertoCheckingthe
EngineOilin,page.
AdjustingtheThrottle
1.Positionthethrottleleverforwardsoitis
approximately1/8inchfromthefrontofthecontrol
armslot.
2.Loosenthethrottlecableconnector,onthethrottle
cable,nexttotheinjectionpumplever(Figure63).
Figure63
1.Throttlecablepivot3.Highidlestop
2.Injectionpumpleverarm4.Throttlecableconnector
3.Holdtheinjectionpumpleverarmagainstthehigh
idlestop(Figure63).
4.Whilepullingthethrottlecable,toremoveanyslack,
tightenthethrottlecableconnector.
Note:Whentightened,thecablepivotmustbefree
toswivelontheinjectionpumpleverarm.
5.Ifthethrottledoesnotstayinpositionduring
operation,increasethetorqueonthelocknut,used
tosetthefrictiondeviceonthethrottlelever.
44