Toro Reelmaster 5510 - Page 574

InstallingtheFrontRoller(continued)
B.Applyanti-seizelubricanttothethreadsoftheboltthatwillextendinto
theheight-of-cut(roller)bracket.
C.Threadtheboltintothebracket.
Note:Whenassemblingtheheight-of-cut(roller)bracketstothesideplate,
ensurethattheboltheadand1washerareabovetheadjustmentangeon
thesideplateandsecondwasherandangenutarebelowtheange.
3.Ifbothfrontheight-of-cut(roller)bracketswereremovedfromthecuttingunit
sideplate,positiononeofthebracketstothesideplate.Securethebracket
tothesideplatewiththecarriagescrewandangenut.
4.Slidethefrontrollershaftintothebracketattachedtothecuttingunit.Slide
thesecondheight-of-cut(roller)bracketontotheotherendoftherollershaft.
Securethesecondbrackettothecuttingunitsideplatewiththecarriage
screwandangenut.
5.ApplyLoctite#243(orequivalent)toexposedthreadsofcapscrew(item1)
betweenangeofsideplateandpositionofangelocknut(item3)oncap
screw.Tightenangelocknutoncapscrewandthenloosennut1/4to1/2
turn.Capscrewshouldrotatefreelywithlittle(ifany)endplayafterlock
nutinstallation.
6.ApplyLoctite#243(orequivalent)tothethreadsofthe2capscrews(item
6).Centerthefrontrollertothecuttingreelandsecureinplacewiththe2
capscrews.Tightenthecapscrewsto20to26N∙m(15to19ft-lb).Secure
thecapscrewswiththeangenuts.
7.Lubricatethefrontroller.
8.Adjustthecuttingunit;refertotheCuttingUnitOperator’sManual.
CuttingUnit:ServiceandRepairs
Page9–44
Reelmaster
®
5410/5510/5610Series
15216SLRevC