Reelmaster 6500–D/6700–D
Page 4 – 75
Hydraulic System
26. Remove and discard the commutator seal from the
commutator cover (Fig. 62).
27. Remove the eleven hex socket head screws, that
hold the metering package together (Fig. 63). Use a
3/32 in. Allen wrench. Inspect the screws for thread and
socket damage and replace as necessary.
28. Lift the commutator cover from the metering pack-
age (Fig. 64).
29. Inspect the ground surfaces of the commutator cov-
er. You should notice a “normal” polished pattern due to
the rotation of the commutator. If the cover has nicks,
burrs, or scoring, it must be replaced.
Figure 62
Figure 63
Figure 64
Hydraulic
System
To Next Page
Loading...
