EasyManuals Logo

Toro SnowMaster User Manual

Toro SnowMaster
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Toro® - SnowMaster® Service Manual
Specications & Maintenance
2
Table of Contents
SPECIFICATIONS AND MAINTENANCE
2-5
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the rst hour
Check for loose fasteners and tighten them if necessary.
After the rst 2 hours
Change the engine oil.
Inspect the auger cable and adjust it if necessary.
Inspect the transmission cable and adjust it if necessary.
Before each use or daily
Check the engine oil level and add oil if necessary.
Every 100 hours
Replace the spark plug.
Yearly
Check the skids and adjust them if necessary.
Inspect the throwing edges and have an Authorized Service Dealer replace the
throwing edges and scraper if necessary.
Change the engine oil.
Inspect the auger cable and adjust it if necessary.
Inspect the transmission cable and adjust it if necessary.
Check the tire pressure.
Check for loose fasteners and tighten them if necessary.
Have an Authorized Service Dealer inspect the drive belt and replace it if necessary.
Yearly or before storage
Prepare the machine for storage.
Maintenance Safety
Read the following safety precautions before performing
any maintenance on the machine:
Before performing any maintenance, service, or
adjustment, stop the engine and remove the key. If
major repairs are ever needed, contact an Authorized
Service Dealer.
Check all fasteners at frequent intervals for proper
tightness to be sure the machine is in safe working
condition.
Maintain or replace safety and instruction labels, as
necessary.
Do not change the governor settings on the engine.
Purchase only genuine Toro replacement parts and
accessories.
Checking the Engine Oil Level
Service Interval: Before each use or daily
1. Remove the dipstick, wipe it clean, then fully insert
the dipstick without threading it in.
2. Remove the dipstick and check the oil level.
If the oil level is below the full mark on the
dipstick (Figure 1), add oil.
If the oil level is above the Full mark, drain
the excess oil until the oil level is at the Full
mark.
Figure 1
1. Low oil level—add oil
2. Correct oil level

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro SnowMaster and is the answer not in the manual?

Toro SnowMaster Specifications

General IconGeneral
BrandToro
ModelSnowMaster
CategorySnow Blower
LanguageEnglish

Related product manuals