Toro® - SnowMaster® Service Manual 3-9
Chassis
3
Table of Contents
CHASSIS
Rotor Removal & Replacement
(Figure 22)(Cont.)
Replacement (Cont.)
3. Install the rubber washer and bearing cap. Ensure
the rubber washer is properly positioned before
installing the bearing cap. Torque bolts to 40-60 in-
lbs. (4.6-7 Nm).
4. Install the bolts that go behind the rotor pulley.
Torque to 60-80 in-lbs. (7-9 Nm).
5. Install the rotor belt and belt cover as outlined in
“Belt Removal & Replacement.”
To Next Page
Loading...
