Toro® - SnowMaster® Service Manual
3-10 Table of Contents
CHASSIS
1. Transmission
2. Jackshaft Support Plate
3. Traction Idler
4. Jackshaft Pulley
5. Idler Pulley
6. Belt
7. Jackshaft
8. Transmission Bearing Support
Spring must be assembled into the slot of the traction
idler arm and hole in jackshaft support plate.
1
2
Ensure idler arm, pivots freely after assembly.
Tire and wheel assemblies, should be assembled so
the tire tread is going in the correct direction.
Assemble items to jackshaft support plate. Then pass
jackshaft assembly through bearing in the left side
of the frame then assemble rotor jackshaft pulley to
jackshaft. Install transmission bearing support after
jackshaft assembly is tightened to left hand side plate.
Insure pulley and shaft rotate freely after assembled.
3
4
Figure 27
Transmission, Drive and Tire
7
2
4
8
5
1
6
3
To Next Page
Loading...
Need help?
General
