Toro TimeCutter 16-42Z - Adjusting the Height of Cut

To stop, putt the motion control levers to neutral, i.-
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Fig. 9).
To go straight, apply equal pressure to both motion control
levers (Fig. 9).
To turn, release the pressure on the motion control lever
toward the direction you want to turn (Fig. 9).
To stop, push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the traction control levers to
neutral and separate to the brake position, disengage the
PTO, ensure the throttle is in the Fast position, and turn the
ignition key to Off. Remember to remove the key from the
ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and move the
motion control levers to the brake position when
leaving the machine unattended, even if just for a
few minutes.
Adjusting the Height of Cut
The height of cut is adjusted from l-1/2 to 4-1/2 inch (3 8 to
114 ram) in 1/2 inch (13 ram) increments by moving the
height-of-cut lever in different locations.
1.
2.
Raise the height-of-cut lever to the transport position
(also the 4-1/2 inch (114 nml) cutting height position)
(Fig. 10).
To adjust, pull up on the height-of-cut lever and move it
to the desired position (Fig. 10).
m-6421
1. Height-of-cut lever
4-1/2 inch (114 mm)
F_
4 inch (102 mm)
E 3-1/2 inch (89 mm)
D -- 3inch (76 mm)
2-1/2 inch (64 mm)
2 inch (51 mm)
j/_ 1-1/2 inch (38 mm)
\
Figure 10
2. Height-of-cut positions
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1.
2.
Raise the seat and loosen the adjustment knobs
(Fig. 11).
Move the seat to the desired position and tighten the
knobs.
1. Adjustment knobs
Figure 11
m-6433
15