The spring is under tension when installed and can
cause personal injury.
Be careful when removing the spring.
6. Route the new belt around the engine pulley and mower
pulleys (Fig. 42).
7. Putt the idler pulley in the direction shown in Figure 42
and route the belt onto the idler pulley (Fig. 42).
8. Rotate the belt guide, on the idler arm, towards the
pulley until it stops (Fig. 42).
9. Tighten the belt guide (Fig. 42).
10. Install the belt covers over the outside spindles.
6
3
\\\\\\\
4
1.
2.
3.
4.
Mower belt
Idler arm
Outside pulley
Spring
2
Figure 42
Top View
5.
6.
7.
Engine pulley
Belt cover
Belt guide
m-7105
Removing the Mower
1. Park the machine on a level surface and disengage the
blade control (PTO).
2.
Move the motion control levers to the brake position,
stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lower the height-of-cut lever to the lowest position.
4.
Remove the hairpin cotter and clevis pin from the front
support rod on each side of the mower.(Fig. 43).
u,/ /
! .... -........
m-6431
Support rod
Figure 43
1. Hairpin cotter and clevis 2.
pin
6.
Remove the hairpin cotter and washer from the
adjusting rod (Fig. 44) on each side of the mower.
On each side of the mower remove the hairpin cotter
and washer at the mower leveling brackets (Fig. 44).
/. ............ ;, / .............................................................................................
j /'
Figure 44
1. Leveling bracket 3. Adjusting rod
2. Hairpin cotter and washer
3 2
m-6437
7. Slide the mower rearward to remove the mower belt
from the engine pulley.
8. Slide the mower out from underneath the tractor.
31
To Next Page
Loading...
