Toro TimeCutter 75734 - Adjusting the Front-to-Rear Blade Slope

g331321
Figure70
1.Woodblock—6.6cm
(2-5/8inches)thick
2.Woodblock—7.3cm
(2-7/8inches)thick
6.Removethehairpincotterandwasherfromthe
lowerlift-armpin(Figure71).
g294197
Figure71
1.Height-of-cutplate
3.Washer
2.Hairpincotter
7.Rotatetheheight-of-cutplatetoadifferenthole
sothatitsupportstheweightofthemowerdeck
afteryouinstalltheplate(Figure72).
g294195
Figure72
8.Installthewasherandhairpincotter(Figure72).
9.Repeatsteps6through8fortheothersideof
themachine.
10.Checktheside-to-sidelevelagain;repeatthis
procedureuntilthemeasurementsarecorrect.
11.Continuelevelingthemowerdeckbychecking
thefront-to-rearbladeslope;refertoChecking
theFront-to-RearBladeSlope(page47).
AdjustingtheFront-to-RearBlade
Slope
1.Rotatetheadjustmentnutinthefrontofthe
mower(Figure73).
g294471
Figure73
1.Adjustingrod3.Adjustmentnut
2.Adjustingblock
2.Toraisethefrontofthemowerdeck,tightenthe
adjustmentnut.
48