9-6
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
ELECTRICAL
Key/Ignition Switch (Cont.)
Testing
1. Remove the control panel from the right console.
2. Disconnect the harness from the ignition switch. Gently rock the connector back and forth until unplugged.
3. Using a digital multi-meter set to the OHM or Continuity setting, verify that continuity exists between the
terminals listed for each switch position.
4. Using a digital multi-meter set to the OHM or Continuity setting, verify that NO continuity exists between the
terminals not listed for each switch position.
Position Circuit “Make”
1. OFF None
2. Run B + R + I + A
3. Start B + R + I + S
To Next Page
Loading...
