Toro TIMECUTTER HD 75211 - Installation

5-27
Digital Edition - TIMECUTTER® HD Service Manual
April 2017
Table of Contents
CHASSIS
Chassis
Choke Control Assembly (Cont.)
Installation
1. Route the choke cable through the control panel assembly.
2. Thread the jam nut over the choke cable up to the control panel assembly (Figure 33).
3. Attach the choke cable assembly to the control panel with the jam nut.
4. Install the control panel assembly into the console.
5. Move the choke control lever to the open position (down) (Figure 34).
Figure 33
Figure 34