Toro TimeCutter series Setup Instructions

Form No. 3356-867 Rev A
TimeCutter® Riding Mower
Model No. All models
Setup Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Charge the battery.
Bolt (1/4 x 3/4 inch)
2
Washer
2
2
Nut (1/4 inch)
2
Connect the battery.
Seat
1
Spacers 2
Flat washers
2
3
Knobs
2
Install the seat.
Control lever
2
4
Bolt (1/4 x 3/4 inch)
4
Install the motion control levers.
Ignition Key
1
Operator’s Manual
1
Engine Operator’s Manual
1
Hose coupling
1
5
Operator Training Material
1
Complete thesetup.
Note: Deter mine the left and right sides of the
mac hine from the nor mal operating position.
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Toro TimeCutter series Specifications

General

Deck Material	Steel
Engine Brand	Kohler, Kawasaki, or Toro
Cutting Height	1 to 4.5 inches
Fuel Capacity	3 gal
Transmission	Hydrostatic
Speed	Up to 7 mph
Warranty	3-year limited warranty
Weight	500-700 lbs