Toro TimeCutter SS 5060 User Manual

Toro TimeCutter SS 5060

108 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Count on it.

0

CL

0

Form No. 3369-575 Rev A

TimeCutter_ SS 4235, SS4260, SS

5000 and SS 5060 Riding Mowers

Model No. 74624mSerial No. 311000001 and Up

Model No. 74625mSerial No. 311000001 and Up

Model No. 74626_Serial No. 311000001 and Up

Model No. 74630_Serial No. 311000001 and Up

Model No. 74632_Serial No. 311000001 and Up

To register your product or download an Operator's Manual or Parts Catalog at no charge, go to www.Toro.com. Original Instructions (EN)

Table of Contents

Questions and Answers:

R
Robert MitchellAug 3, 2025
Why won't my Toro TimeCutter SS 5060 Lawn Mower engine start?
- J
  justin71Aug 3, 2025
  If your Toro Lawn Mower engine is not starting, starts with difficulty, or stops running, several factors could be at play. First, ensure that the fuel tank isn't empty by filling it. If that's not the issue, check if the choke is properly engaged by moving the choke lever to the 'On' position. A dirty air cleaner can also cause problems, so clean or replace it. Inspect the spark plug wire(s) to ensure they are securely connected to the spark plug. If the spark plug(s) is damaged, replace it with a new, correctly gapped one. Also, replace the fuel filter if it's dirty. If there is incorrect fuel in the fuel tank, drain the tank and replace the fuel with the proper type. Finally, make sure that the oil level in the crankcase isn't low by adding oil to the crankcase.
R
Rita MartinezAug 7, 2025
Why is my Toro TimeCutter SS 5060 engine overheating?
- R
  Robin KellyAug 7, 2025
  If your Toro Lawn Mower engine overheats, several factors could be the cause. Start by reducing the ground speed, as the engine load might be excessive. Check the oil level in the crankcase and add oil if it's low. Ensure that the cooling fins and air passages under the engine blower housing are free from obstructions. Also, clean or replace the air-cleaner element if it's dirty.
K
Kristen RobertsonAug 11, 2025
What to do if my Toro TimeCutter SS 5060 engine loses power?
- A
  Amanda ClaytonAug 11, 2025
  If your Toro Lawn Mower engine loses power, it could be due to several reasons. Try reducing the ground speed, as the engine load may be excessive. Another cause could be a dirty air cleaner, so try cleaning it. Check the oil level in the crankcase and add oil if it's low. Also, remove any obstructions from the cooling fins and air passages under the engine blower housing. Finally, the spark plug(s) might be pitted, fouled, or have an incorrect gap, so install a new, correctly gapped spark plug(s).
M
Matthew TaylorAug 15, 2025
How to fix uneven cutting height on my Toro TimeCutter SS 5060?
- V
  Virginia LloydAug 15, 2025
  If the cutting height on your Toro Lawn Mower is uneven, several factors could be the cause. Start by sharpening the blade(s). If that doesn't resolve the issue, the cutting blade(s) might be bent, in which case you should install a new cutting blade(s). Ensure that the mower is level from side to side and front to rear. Check that the anti-scalp wheel is set correctly and adjust its height if necessary. Clean the underside of the mower, as a dirty underside can affect cutting height. Finally, ensure the tire pressure is correct and adjust if needed.
D
Donna RamirezAug 20, 2025
How to fix a Toro TimeCutter SS 5060 when the starter does not crank?
- S
  Shannon RomeroAug 20, 2025
  If the starter on your Toro Lawn Mower isn't cranking, make sure the blade-control switch is disengaged. Also, ensure the motion-control levers are in the park position. If these aren't the issue, the battery might be dead, so charge it. Check the electrical connections for any corrosion or looseness, and replace the fuse if it's blown.
W
whitney03Aug 25, 2025
Why is my Toro TimeCutter SS 5060 Lawn Mower vibrating abnormally?
- R
  Raymond JohnsonAug 25, 2025
  If you're experiencing an abnormal vibration with your Toro Lawn Mower, begin by checking if the engine-mounting bolts are loose and tighten them if necessary. Inspect the engine pulley, idler pulley, or blade pulley for looseness and tighten the appropriate pulley. If the cutting blade(s) is/are bent or unbalanced, install a new cutting blade(s). Check if a blade mounting bolt is loose and tighten it.
R
Rebecca JimenezAug 28, 2025
What to do if the blades don't rotate on my Toro Lawn Mower?
- J
  Jason BrockAug 28, 2025
  If the blades on your Toro Lawn Mower aren't rotating, the drive belt might be worn, loose, or broken, so install a new drive belt. Another possibility is that the drive belt is off of the pulley, so install the drive belt and check the adjusting shafts and belt guides for the correct position. The mower belt could also be worn, loose, or broken, so install a new mower belt.

Toro TimeCutter SS 5060 Specifications

General

Brand	Toro
Model	TimeCutter SS 5060
Category	Lawn Mower
Language	English

Related product manuals

Preview: Toro TimeCutter SS 5000

Toro TimeCutter SS 5000

Toro TimeCutter SS 5425

Toro TimeCutter SS 4235

Preview: Toro TimeCutter SS 4225

Toro TimeCutter SS 4225

Toro TimeCutter SS 4260

Toro TimeCutter SS 4250

Preview: Toro TimeCutter SS 4200

Toro TimeCutter SS 4200

Toro TimeCutter SS 3200

Preview: Toro 74710 TimeCutter SS 3225

Toro 74710 TimeCutter SS 3225

Preview: Toro TimeCutter SS 4216 74616

Toro TimeCutter SS 4216 74616

Preview: Toro TimeCutter SS 4200 74720

Toro TimeCutter SS 4200 74720

Preview: Toro TimeCutter SW4200

Toro TimeCutter SW4200