.
Install the blade stiffener (42 inch models only), the
curved washer (cupped side toward the blade) and
the blade bolt (Figure 48).
3. Torque the blade bolt to 35-65 ft-lb (47-88 N-m).
2
G009682
Leveling the Mower Deck
Check to ensure the mower deck is level any time you
install the mower or when you see an uneven cut on
your lawn.
The mower deck must be checked for bent blades
prior to leveling; any bent blades must be removed
and replaced. Refer to the Checking for Bent Blades
procedure before continuing.
The mower deck must be leveled side-to-side first then
the front to rear slope can be adjusted.
Requirements:
• The machine must be on a level surface.
• All four tire must be properly inflated. Refer to
Checking the Tire Pressure in the Drive System
Maintenance section.
Side-to-Side Leveling
1. Park the machine on a level surface and disengage
the blade control switch.
.
.
4.
Move the motion control levers outward to the
park position, stop the engine, remove the ke), and
wait for all moving parts to stop before leaving the
operating position.
Set the height-of-cut lever to middle position.
Carefully rotate the blades so that they are all side to
side (Figure 5i and Figure 52).
.
.
.
Figure 51
Mower Decks with 2 Blades
1. Blades side to side 3. Outside cutting edges
2. Sail area of blade 4. Measure from the tip of the
blade to the flat surface
here
G005278
2\
Figure 52
Mower Decks with 3 Blades
1. Blades side to side 3. Sail area of blade
2. Outside cutting edges 4. Measure from the tip of the
blade to the flat surface
here
Measure between the outside cutting edges and
the flat surface (Figure 5i and Figure 52). If both
measurements are not within 3/i6 inch (5 mm), an
adjustment is required; continue with this procedure.
Support the weight of mower deck by placing wood
blocks under the edges of the deck.
Note: Avoid placing the supports under any
anti-scalp rollers if present on the deck.
Move to the left side of the machine. Remove the
side carriage bolt and locking nut from the fixed
position and install it into the rear, slotted position
and leave it slightly loose (Figure 53).
4O
To Next Page
Loading...
