Toro TimeCutter SS 3200 - Page 37

G009682
1
2
2
3
3
4
4
Figure50
MowerDeckswithTwoBlades
1.Bladessidetoside
3.Outsidecuttingedges
2.Sailareaofblade4.Measurefromthetipofthe
bladetotheatsurface
here
5.Measurebetweentheoutsidecuttingedgesandthe
atsurface(
Figure50).Ifbothmeasurements
arenotwithin3/16inch(5mm),anadjustmentis
required;continuewiththisprocedure.
6.Supporttheweightofmowerdeckbyplacingwood
blocksundertheedgesofthedeck.
Note:Avoidplacingthesupportsunderany
anti-scalprollersifpresentonthedeck.
7.Movetotheleftsideofthemachine.Removethe
sidecarriageboltandlockingnutfromthexed
positionandinstallitintotherear,slottedposition
(
Figure51).Leavethelocknutslightlyloose.
G015323
1
2
3
4
5
Figure51
1.Hangerbracket
4.Sidelockingnut.
2.Slottedadjustment
position
5.Sidecarriagebolt
3.Fixedposition
8.Loosentherearlockingnutonthehangerbracket
justenoughtoallowthehangertobeadjusted
(Figure51).
G015324
1
2
3
4
Figure52
1.Hangerbracket
3.Sidelockingnut,slotted
position.
2.Rearlockingnut4.Adjustmentnotches
9.Usethenotchesontheweldedbrackettomeasure
theamountofadjustment.Eachnotchsurfaceis
equivalentto0.25inch,whileasinglesideis0.125
inch(Figure53).Adjusttheheightofthemower
decktothedesiredheight.
G015325
1
2
Figure53
1.0.25inch2.0.125inch
10.Stopthedeckattheadjustedpositionandtightenthe
rearlockingnutonthehangerbrackettoholdthe
newposition(Figure52).Tightenthesidelocking
nutonthehangerbracket.
11.Continuelevelingthedeckbycheckingthe
front-to-rearbladeslope;refertoAdjustingthe
Front-to-RearBladeSlope.
37