EasyManua.ls Logo

Toro TimeCutter SS 5060 - Page 31

Toro TimeCutter SS 5060
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Every 100 hours--Change the engine
oil. (more often in dusty, dirty
conditions)
Note: Dispose of the used oil at a recycling center.
1. Start the engine and let it run five minutes. This
warms the oil so it drains better.
.
.
Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil drains
completely.
Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
4. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 31).
Figure 31
G01497_
.
Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil
to bring it to the Full mark (Figure 32).
1
3
5
m
2
4
6
Figure 32
G008796
Changing the Engine Oil Filter
Service Interval: Every 200 hours--Change the oil
filter. (more often in dusty, dirty
conditions)
Note: Change the engine oil filter more frequently
when operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to (;hanging the
Engine Oil.
2. Change the engine oil filter (Figure 33).
31

Table of Contents

Related product manuals