Toro TIMECUTTER Z18-52 - Control Handle-Return to Neutral Adjustment

5 - 14 TimeCutter™ Z Service Manual
TRANSAXLE
5
1. With the engine off, move the directional
control handles to the reverse position.
2. Let the handles go. They should return to
the neutral position, which means the handle
should line up with the neutral slot (neutral
lockout position).
3. If adjustment is needed:
A. Lift the seat and located the adjusters.
Loosen the jam nut on the yoke.
0702-0519
0702-0520
0702-0521
Control Handle-Return To Neutral Adjustment