TRANSAXLE
TimeCutter™ Z Service Manual 5 - 19
5
6. Place the directional control handles in the
neutral lockout position. Start the engine
and run at half throttle.
7. The rear traction wheels should remain
stationary or creep slightly in reverse.
8. If necessary, loosen the jam nuts (A) and
turn the control rod until the wheel stops
between forward and reverse. In some
cases, you may have a slight creep in
reverse. When you lower the unit to the
ground, it should stop.
A
0702-0526
0702-0527
0702-05028
To Next Page
Loading...
